Zavio D7110 Installationsanleitung PDF herunterladen (Seite 3)

Install the hardware and make all cable connection

a. Install the hardware

1. Connect the adaptor to the supplied 2pin I/O terminal block which shows positive and negative polarity on it.

Please make sure the marked red wire should connect with the positive polarity or device won’t work.

2. Loosen the tamper-proof screws using supplied special hex wrench and remove the dome cover from the rugged

dome. Be careful do not scratch the cover glass.

3. Disassemble the cable gland.

4. Thread the network and I/O cable (power/digital input and digital output) through thread-lock sealing nut, claw

(using the claw to round all cable) and cable gland. To seal all cable in the claw part tightly in case of water

leaking.

5. Attach the cable gland to the conduit hole on the side or bottom of the rugged dome. Push the claw into the cable

gland and tighten thread-lock sealing nut to secure the cables.

6. Use the supplied blind plug to fill unused conduit hole.

7. Use the cable gland is optional. For vandal-proof requirement of the cables, use vandal-proof conduits instead.

b. Wall mounting and Ceiling mounting

1. Attach the alignment sticker to the wall/ceiling and drill two pilot holes into it.

2. Hammer the supplied plastic anchors into the holes.

3. Align the three holes on the base of camera with the three plastic anchors on the wall and ceiling, insert the

supplied screws to the corresponding hole and screw them.

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

Zavio D7110 Installationsanleitung Seite 3